Production Planning - SAP HANA

PP Module covers –

·         Applicable Master data

o   Material Master (Comes under the MM module) MM01,MM02,MM03

o   BOM (TCodes – CS01, CS02, CS03)

o   Routing (TCodes – CA01, CA02, CA03)

o   Versions (TCode - C223)

o   Work Center (TCodes – CR01, CR02, CR03)

§  Scheduling

§  Capacity

§  Costing

·         Planning              

o   Demand Management (Make to Stock/Make to Order)

o   Material Requirement Planning (MRP Run)

o   Production Orders

o   Production Order Confirmation

o   Production Order Close

·         Repetitive Manufacturing (REM Confirmation (TCode – MFBF)

o   Make to Order (Manufacturing for Customer orders)

o   Make to Stock (Repetitive manufacturing)

Repetitive Manufacturing

1. ·         Requesting of materials from the Stores to the Production floor (Item reservation – TCode - MB21)
2. ·         Transfer posting (to bring raw materials to the production floor) (TCode – MIGO)
3. ·         REM Confirmation (Manufacturing data is entered to the system) (TCode – MFBF)
4. ·         Quality inspection (Quality check to either Accept/Reject the finished goods) (TCode – QA32)
5. ·         Transfer posting (to take the finished goods from the production floor to the finished goods store) (TCode – MIGO)

In the REM Confirmation , when you  record the production, you could direct them to a default storage location. This location is defined in the Material master data – Work Scheduling – Production Storage Location

To view the GL entries – Go to TCode MIGO – Display Document information – Provide the Document number which was generated in the REM Confirmation

To view an already recorded REM Confirmation – Tcode – MF12